- Models: A-775 · ZA-775 · KDT-360DJ
- Edge Finishing
About the Automatic Edge Bander
An automatic edge bander is what separates factory-finished modular furniture from carpentry. The panel enters one end and leaves the other with tape applied, ends trimmed flush, edges radiused, glue line scraped and the surface buffed — typically at 12 to 20 metres per minute.
High frequency trimming motors slide on precise guideways so the finish stays consistent through a long production shift. Pre-milling cleans the panel edge before glue is applied, which is the single biggest factor in a glue line that will not open up later.
Key features
- Process line: pre-milling → gluing → end trimming → fine trimming → scraping → buffing
- Handles PVC, ABS, acrylic and veneer tape from 0.4 to 3 mm
- High frequency trimming motors on precision guide ways
- Corner rounding with pre-milling available on ZA-775
- Temperature controlled glue pot with quick-clean pre-melt
- Feed speed 12–20 m/min for continuous batch production
Technical specifications
| Parameter | KDT-360DJ |
|---|---|
| Minimum panel width | 80 mm |
| Panel thickness | 10 – 60 mm |
| Edge tape thickness | 0.4 – 3 mm |
| Feed speed | 12 – 20 m/min |
| Working air pressure | 6 kg/cm² |
Design and specifications are subject to change without prior notice.
Typical applications
- Kitchen shutter edges
- Wardrobe carcass panels
- Office furniture tops
- Store fixture panels